#1645: WS2812B RGB 5050 LED Module

R25.80

• WS2813B is a set of control circuit and lighting circuit in one of the smart external control LED light source. Its shape and a same 5050LED lamp beads, each element is a pixel. Pixels contained within an intelligent digital interface data latch signal shaping amplification drive circuit further includes a high-precision internal oscillator and programmable 12V high voltage constant current control section, effectively ensuring the color pixel light highly consistent.
• NRZ data protocol uses a single line of communication, pixel after power-on reset, DIN end receives data transmitted from the controller, the first sent over 24bit pixel data is extracted first point, to the internal pixels data latch, the remaining data processing circuit through the internal plastic shaping amplified through the DO output port begins forwarding to the next cascade of pixels, each pixel through the transmission of a signal to reduce 24bit. Pixel using automatic shaping forwarding technology, so the number of pixels of the cascade unrestricted signal transmission, only limited by the signal transmission speed requirements.
• LED has a low voltage driving, high energy saving and environmental protection, brightness, scattering angle, consistency, and ultra-low-power, long life and other advantages. The control circuit is integrated in the LED above the circuit becomes more simple, small size, installation more convenient.
• • Smart reverse protection, power supply reverse polarity will not damage the IC.
  • IC control circuit and a power LED spot light utility.
  • Control circuit chip with RGB components in a package in 5050, to form a complete external control pixels.
  • built-in signal shaping circuit, any one pixel signal is received through the waveform shaping and then output to ensure line waveform distortion will not accumulate.
  • Built-in power-on reset and brown-out reset circuit.
  • trichromatic color of each pixel of the display brightness can achieve 256, 16777216 colors to complete the full true color display, the scanning frequency of not less than 400Hz / s.
  • serial cascade interface, through a signal line to complete the receiving and decoding of data.
  • transfer transmission distance between any two points in less than 5 meters without any additional circuitry.
  • When the refresh rate of 30 frames / sec, cascading number of not less than 1024 points.
  • data transmission speeds of up to 800Kbps.